Easi-Dentrite Kit

Ayce Systems' Easi-Dentrite is a simple to use glue puller for the removal of small shallow dents that are inaccessible using conventional PDR tools. Repairs are carried out by attaching the relevant glue pulling tab to the panel using our high strength hot melt glue.

Allow to cool for approximately 30 seconds. Place bridge over thread of foot and attach pressure screw. Tighten down pressure screw until firm resistance is felt. Continue to tighten screw in small steps, allowing short intervals between each turn, until the dent is removed.

A high spot remover is also included to finish off any imperfections.

Kit Contents

• 1 x Glue Gun
• 1 x Aluminium Bridge
• 2 x Plastic Feed (45mm) c/w 8mm Stud
• 1 x 50mm Round Glue Pulling Tab
• 1 x 30mm Oval Glue Pulling Tab
• 2 x 6mm x 50mm Stud
• 1 x Pack of 5 Glue Sticks
• 1 x Plastic Dent Punch
• 1 x Plastic Spatula
• 1 x Glue Pulling Knob (6mm)
• 2 x Bridge Feed Adjusting Knob (8mm)
• 1 x Carry Case c/w Foam Insert

PRODUCT CODE: EASYDENT
DESCRIPTION: Easi-Dentrite Kit
QUANTITY: 1 Kit